A Simple Step-by-Step Guide to a Beautiful Finish
Our premium non-woven wallpapers are custom-made to fit your wall dimensions. Each strip is numbered in sequence to make installation easier. Follow these steps for the best results.
STEP 1 — PREPARE YOUR WALL
Make sure the wall is clean, dry, smooth, and free from dust, grease, and loose paint.
Remove any existing wallpaper, fill holes or cracks, and allow repaired areas to dry completely. For the best results, the wall should have a uniform, light-colored surface.
Apply a suitable wallpaper primer if necessary, following the manufacturer’s instructions.
STEP 2 — PREPARE YOUR TOOLS
Before starting, make sure you have the following:
●Non-woven wallpaper adhesive
●A roller or brush for applying adhesive
●A tape measure and pencil
●A spirit level
●A wallpaper smoothing tool or soft brush
●A sharp utility knife
●A straight edge
●A clean sponge or soft cloth
STEP 3 — CHECK YOUR WALLPAPER STRIPS
Carefully unpack your wallpaper and inspect all strips for visible defects or damage before installation.
Each strip is numbered to indicate its installation order. Arrange the strips in numerical order before you begin.
Important: Strip No. 1 must be installed on the right-hand side of the wall. Continue installing the remaining strips from right to left, following the numbered sequence.
If you notice any defects, stop before installation and contact our customer support team.
STEP 4 — APPLY THE ADHESIVE
Use a high-quality adhesive specifically designed for non-woven wallpaper.
Apply the adhesive evenly to the wall where the first strip will be installed, following the adhesive manufacturer’s instructions.
Work in manageable sections to prevent the adhesive from drying before the wallpaper is applied.
STEP 5 — INSTALL STRIP NO. 1
Begin with strip No. 1 on the right-hand side of the wall.
Use a spirit level to mark a straight vertical guide line. This will help you position the first strip correctly, even if the wall or corner is not perfectly straight.
Carefully position the strip along the guide line, leaving a small amount of excess material at the top and bottom for trimming.
Gently smooth the wallpaper from the center outward to remove air bubbles and wrinkles. Avoid stretching or pulling the material.
STEP 6 — ALIGN AND INSTALL THE REMAINING STRIPS
Continue with strip No. 2, placing it to the left of strip No. 1. Install the remaining strips in numerical order, working from right to left.
The wallpaper strips must be joined edge to edge, with no overlap. Align the edges carefully so they meet precisely at the seam, with no gaps between them.
Make sure the design aligns correctly across each seam to create a continuous, seamless-looking pattern.
Smooth each strip gently, checking the alignment before moving on to the next.
STEP 7 — TRIM THE EXCESS WALLPAPER
Once the strips are positioned correctly, carefully trim the excess material along the ceiling, skirting boards, and other edges.
Use a sharp utility knife and a straight edge for a clean finish. Replace the blade when necessary to avoid tearing the wallpaper.
Remove any excess adhesive from the wallpaper surface promptly with a clean, slightly damp sponge, following the adhesive manufacturer’s instructions. Avoid excessive rubbing.
STEP 8 — ALLOW THE WALLPAPER TO DRY
Allow the wallpaper to dry naturally according to the adhesive manufacturer’s instructions.
Keep the room at a stable temperature and avoid strong drafts, direct heat, or rapid drying.
Avoid pulling or repositioning the wallpaper unnecessarily while it dries.
STEP 9 — ENJOY YOUR NEW SPACE
Once the wallpaper is completely dry, admire your finished wall and enjoy your transformed interior
